1. Clean surface to be wrapped. Cut off length to be used.

2. Peel back a short length of protective film. Keep tape clean and dry.

3. Begin with one complete overlap of tape onto itself.

4. STRETCH CoaxWrap™ while continuing to wrap object with “half-laps”, removing clear film as you go. For greater pressure resistance, use 2 or more tightly wrapped layers.

5. End of tape at final wrap should be completely positioned onto itself.

Note: CoaxWrap™’s bond begins to cure immediately upon contact with itself. Repositioning or removal is not recommended after 2 minutes of wrapping.

CoaxWrap™ will form a permanent, cohesive bond within 24 hours at room temperature... faster if heat cured at up to 350ºF.